Adjust LSD Settings

[Deleted]

Thanks to raflo83 for this

I have done the following change on a 2014 Seat Cupra 280

I change the LSD settings from Standard to increased Traction and taken her for a quick spin and can feel the difference

Coding is (as per above link)

Select Control Unit 32 Lock Electronics
Select Adaptations
Then take Acoustic measure, wiring logic
It should be set to Standard but you can change it to increased Traction from the drop down list.

Save with Green Tick.

Then Select Basic Settings in the same module and run resetting of all adaption values.

Please note any changes to your car following this code are at your own risk.

Make sure you take a backup first in case of issues.

[Shaun worsfold]

Can you do this with the dsg or not ?

[Deleted]

Yes I did it to my DSG car.

[Shaun worsfold]

Did it cause throttle stop or make it much better

[Deleted]

Cant say I have seen any comments about the breaks (other than its in the ABS Control unit).

I noticed the difference on day one but i have lots of very windy, narrow, badly made up roads where i live and the car stays much more planted under speed.

What i always say to people, make the change and see if you can feel the difference, if you cant then put it back to stock.

[Shaun worsfold]

The only problem is I don’t had an android or vagcom have to find someone haha

[Deleted]

Give a shout out on the MK3 Leon forum and ask if there is anybody in your area who can help you, or bite the bullet and get a cheap android device. If you only want simple changes then caristaapp can help but this sort of stuff is not covered.

[Shaun worsfold]

If I have the android device would it work with the caristaapp dongle

[Shaun worsfold]

And did it make much difference on the car mate

[Deleted]

No caristaapp uses a generic OBD2 Device ELM327 from memory, caristaapp I dont think can do this because its for simple changes not for stuff like this.
OBD11 and VCDS Both use there own specific dongles so I am afraid you need to buy one if you want to use OBD11.

With regards to making a difference, for me where i live it makes a noticeable difference keeps my car planted very well on B Roads that i am surrounded by and the Cupra is designed to use on full power but the only way to find out it change it and try, if you dont notice it then turn it back.

[alphahelix]

Hi there - do you know if it is possible to reset the learned adaptions with OBDeleven? In VCDS it is possible to reset all adaptions for the LSD but I am unsure if this can be done via OBDeleven. Thanks !

[Deleted]

If you look at my control unit forum.obdeleven.com/thread/3262/control-unit-setup thread and check under Basic Settings.

There you should see Resetting of all adaptation values

For the DSG you have more options

Reset CAN installation info
Reset clutch characteristic curve
Reset driving percentages per selector level position
Reset gear selector data
Reset logging data for clutch 1
Reset logging data for clutch 2
Resetting of all adaption values