Park pilot module 76 to PLA 3.0

[Carolco]

Hi everybody .

i am changing the unit of module 76 from park pilot to PLA 3.0. I changed the module, and don’t have a complete backup of all of parameters in the adaptations.

anyone with park pilot and 17” wheels can share the adaptations of 76 module. It will be interesting something with PLA 3.0 too for see the differences.

thanks so much

[vwjap]

I think I got 18’s

[vwjap]

Long coding:
0B71067151
Adaptations:
Speaker volume for rear park assist:
Stage 6
Speaker frequency for rear park assist:
Stage 4
Speaker volume for front park assist:
Stage 4
Speaker frequency for front park assist:
Stage 6
Audio reduction request:
On
Park assist activation tone:
On
Switch-off speed for parking assist:
15 km/h
Increment for convertible volume levels:
255
Convertible offset for volume level 1:
255
Acoustic warning for rear lid assistant:
not active
Deactivation of start-stop function:
Start-stop function in control module active
Switch-on speed for parallel parking assist:
37 km/h
Wheel circ.:
1970 mm
Distance to curb:
15 cm
Activating and deactivating all development messages:
Dev_Id_Low_Nibble:
Not activated
Dev_Id_High_Nibble:
Not activated
Production mode:
Deactivating
Deactivate production mode:
Deactivating
Customer-oriented off-road trip:
Not activated
ARA angle control parameter:
Vehicle overhang:
0.764 m
Max. controllable corners:
0.189 1/m
Max. selectable corners:
1.308 1/m
Automatic activation:
activated

[Carolco]

Thanks so much.

[ofektal8]

Did you have PLA 2.0 And you upgraded to 3.0?

Does the front parking work? and the auto braking?

[newty]

Front parking should work, as Long as the cluster is able to show correct graphics (all fl golfs should have the right software).
But nobody will ever front park how pla3 would do, as it its incredible clumsy with this.

For maneuver braking, you will have to change the abs coding: Enable 24/5 disable 27/1)
(Plus you will have to be lucky, as not all firmware/dataset combos will allow this)

[Carolco]

Hello.

first I had installed the control module and it works without Faults. Only had codificated the used module PLA 3.0 and erase the faults. This module have the same codification like the original park pilot module. 

the idea it is go from park pilot from stock to PLA 3.0. The coding it is not problem, because I think that it will work.

the next step is conect the two front sensors and the two back sensors. And the button from the console.

step by step