|
Post by robno1 on Dec 5, 2018 15:16:07 GMT
Hi all, Anyone good at long coding? I have a weird issue: Auto lights are on and lowbeam on always..... checked fuse all ok, checked sensor all ok (covered it and got welcome lights working, uncovered they dont come on - daytime). I went into my OBDEleven and turned off auto lights (they turn off) turn back on and back to low beams also. Not an issue as such as the sensors and everything else are clearly working, just cant see why the low beams are on? only App adaption i made was for corner lights with turning (now off) and not sure if it started after that point. thanks all
|
|
|
Post by robno1 on Dec 7, 2018 15:07:10 GMT
So it appeared to be my auto lights were too sensitive and followed this instruction and now they turn on as dusk kicks in instead of just a dull day:
Instructions: 09-Cent Elec Coding - 07 1 - 8K0 955 559 - RLS (the drop-down menu) Assistant for coding Byte 1 = light sensor correction value Byte 2 = rain sensor correction value
How to calculate the value and behaves: The value that is entered in bytes, is a hexadecimal percentage. That is, 00 = 0% and 64 = 100%. The higher the value, the former turns the light on / the windshield wipers. Previously, he was standing with my light sensor to 56 (86%). Now I have it set to 0A (10%) I felt the behavior after a short test to be quite perfect. You can play around with the values and try it a little and see what appeals to you
|
|
|
Post by henke82 on Jun 2, 2022 18:51:21 GMT
How do you select coding 7?
|
|
anor
New Member
Posts: 4
|
Post by anor on Jun 3, 2022 20:49:06 GMT
Coding-07 just means that he used long coding to change values.
|
|