|
|
Post by anthonylj on Nov 26, 2021 14:48:41 GMT
So I replaced my engine, is there a way to hard reset all the codes and ADAPTATIONS? For example, my the power steering rack was pulled and now I have power steering when the car is off. Also, my coolant low warning light won't clear by hitting the clear codes. What am I missing?
|
|
|
|
Post by dv52 (Australia) on Nov 26, 2021 20:09:23 GMT
anthonylj: short answer is NO, alas. When you say "I replaced my engine", how much of the engine did you replace? For example, did you replace the Engine Control Module (ECM)? My suggestion is that you address the errors that are likely present on your scan report (one-by-one) - because these are the issues that the CAN bus have identified as being problematic after the engine refit Don
|
|
|
|
Post by anthonylj on Nov 30, 2021 22:41:54 GMT
I physically replaced the whole engine lol and that's it. Swapped it with the same exact thing. We pulled the battery and subframe.
|
|
|
|
Post by dv52 (Australia) on Nov 30, 2021 23:32:44 GMT
anthony: post-up a copy of the scan report- so we can see the health of the car is after the retrofit!!
If you are not familiar with how to digitize an OBD11 scan report - see below:
Don
|
|
