|
Post by busydiver on Mar 18, 2024 23:11:57 GMT
I was checking on the timing chain 2018 A4 2.0 and following the correct place to go on live data/engine I don’t get anything close to a number between 0 to -5 degrees …what I get is 37.5’ F…it’s seems it’s reading a temp and not a variation on timing ? I have selected all of the phase options and the readout is not what I am expecting. I checked this back in Jan and I got -3.5 degrees so what changed in this time? Is it an issue with the OBDeleven software?
|
|
|
Post by whataboutthis on Mar 18, 2024 23:24:01 GMT
one possible issue is if you have Metric or Imperial on your settings screen I have seen this sort of output error on certain fields due to this. Just went back and checked my bug list and here is the picture to show what you are talking about.
on the left were Metric but on the right from the same car, same time but using Imperial for some reason have turned degrees into degrees temp.
|
|
|
Post by busydiver on Mar 18, 2024 23:35:18 GMT
one possible issue is if you have Metric or Imperial on your settings screen I have seen this sort of output error on certain fields due to this. Just went back and checked my bug list and here is the picture to show what you are talking about.
on the left were Metric but on the right from the same car, same time but using Imperial for some reason have turned degrees into degrees temp.
|
|
|
Post by busydiver on Mar 18, 2024 23:36:33 GMT
Great and thanks for the information. I will try again later the current settings are imperial so I will switch to Metric.
Thank you again
|
|