|
|
Post by Gianni on Jan 26, 2018 15:26:47 GMT
Can someone provide a guide to permanently disable the Start and Stop system? It would be nice to be able to reverse the operation of the button. I have a DSG gearbox and the car goes off every crossing.
|
|
|
|
Post by adriang on Jan 27, 2018 20:32:10 GMT
Can someone provide a guide to permanently disable the Start and Stop system? It would be nice to be able to reverse the operation of the button. I have a DSG gearbox and the car goes off every crossing. Go to Module 19 (Can Gateway) ·Adaption ·Go to Kanaal: Start_stop_voltage_limit ·change to 12.1V ( standaard is 7.6V) The Start-Stop will show as disabled because the energy requirement from the car is too high, which is not an error but a valid reason for SS to be disabled. |
|
|
|
Post by Gianni on Jan 28, 2018 6:58:24 GMT
thank you. I tried and it works.
I read on forums where they talk about vagcom that someone has managed to reverse the operation of the button. Now the start and stop is active at every power-up even if I had previously disabled it. after modification, the control unit remembers the position before switching off. the modification is done in the control unit 9, channel 34 adaptation. However, with obdeleven I can not find the channel 34.
does anyone know what I'm talking about?
|
|
|
|
Post by Halfmillion on Jan 28, 2018 16:10:16 GMT
Gianni, There are different components, not all cars are equal. Channels identified by numbers were used by old models (golf 6, for instance). In italian: occhio alla fonte quando leggi genericamente di VAG....ogni modello fa storia a sé  |
|
|
|
Post by Gianni on Jan 29, 2018 8:24:34 GMT
Gianni, There are different components, not all cars are equal. Channels identified by numbers were used by old models (golf 6, for instance). In italian: occhio alla fonte quando leggi genericamente di VAG....ogni modello fa storia a sé Grazie. Non c'è modo di attivare la memorizzazione del tasto? |
|
|
|
Post by Halfmillion on Jan 30, 2018 7:49:11 GMT
No
(In english: unfortunately I confirm there is no way to keep start/stop active, reversing the button logic - i.e. default S/S disabled)
|
|
