|
|
Post by sunny021 on Mar 4, 2018 14:21:25 GMT
hi All
I am new to the forum
got my obdeleven a while ago and today I done a full scan and keep getting this error in the dashboard app
"no basic settings" B201000
anyone else has the same issue
the only answer on the internet is "don't worry about it"
I don't think this is normal
|
|
|
|
Post by k4mikz3 on Feb 10, 2019 16:36:59 GMT
hi All I am new to the forum got my obdeleven a while ago and today I done a full scan and keep getting this error in the dashboard app "no basic settings" B201000 anyone else has the same issue the only answer on the internet is "don't worry about it" I don't think this is normal Yea I have the same problem and it's the rear flap motor for the ac vent(mine is broken) and it gives me a malfunction(a6 c7 2012 3.0t prestige) |
|
|
|
Post by mrsidders on Mar 11, 2019 19:04:17 GMT
hi All I am new to the forum got my obdeleven a while ago and today I done a full scan and keep getting this error in the dashboard app "no basic settings" B201000 anyone else has the same issue the only answer on the internet is "don't worry about it" I don't think this is normal Yea I have the same problem and it's the rear flap motor for the ac vent(mine is broken) and it gives me a malfunction(a6 c7 2012 3.0t prestige) |
|
|
|
Post by mrsidders on Mar 11, 2019 19:06:13 GMT
My Q3 has just put this fault out bit concerned. do you reckon It's the same as your ac vent
|
|
|
|
Post by Goldenzrule on Dec 14, 2019 23:17:30 GMT
I have a 2013 S6 and just got my OBDEleven in today and scanned and cleared codes. When I rescanned, the only ones that remained were the one mentioned and cod B10D322, which the google link says is the Left Rear upper body vent motor.
I did sit in the back seat with my newborn son while my wife ran into her doctor appointment and did notice I was not getting much air from that vent, so I guess that makes sense.
|
|
|
|
Post by paulb23 on Dec 30, 2020 21:35:34 GMT
I found the error to be caused by the dash handbrake light being on. I scanned the car again with the hand brake off so no lights on the dash and the code was gone. Soon as i scanned with the hand brake on the code came back, done it again and it was gone. Didn’t have to clear any codes.
|
|
|
|
Post by adnando on Aug 15, 2022 15:34:47 GMT
Hello
After have use output test kanal 08 air conditioning, flap motor with obd eleven on my audi q5 fy 2017, get fault code b20100 basic settings missing. Fault is permanent. Somebody had this problem?
|
|
|
|
Post by jesberi on Dec 15, 2023 14:26:02 GMT
hi All I am new to the forum got my obdeleven a while ago and today I done a full scan and keep getting this error in the dashboard app "no basic settings" B201000 anyone else has the same issue the only answer on the internet is "don't worry about it" I don't think this is normal i had the same fault code B201000, i went to press reset all custom values. to fix it, I had to take the car to a glass shop, where adas calibration was done |
|
