|
Post by zedocoding on Oct 23, 2023 2:14:22 GMT
11A035710 Broadband loudspeaker The other is no longer in production.
The 10A035710 is the harman kardon woofer for id3 rear, full range. 2ohm 50w, large coil. I instaled it on my id3. understand. - With the Harman Kardon system 2. The front woofers have 4 wires going to them - why? Because hk front woofer have double coil. A very good speaker. Here's the 6 speaker system Where is connected the center speaker on the dash? I'm thinking disconnect it size I have focal on front. ___/_/_________ Other thing, 1clickapp for rear speakers retrofit set the topology to 19. In my case I feel lack of front bass and excessive bass on rear . 😐
|
|
ID.3
Full Member
Posts: 210
|
Post by ID.3 on Oct 23, 2023 17:33:38 GMT
I don't know where the central speaker is plugged in, but you should leave it as it is, it's normally the one that will give you an alert in the event of a crash, but check? If you don't want to have it any more, just disconnect it directly at the bottom of the speaker. If not, you need to follow the wires to see if it's connected in parallel to the other front speakers?
As for the type of signal, you can leave it as it is, personally I don't hear any difference.
|
|
|
Post by seiger on Oct 31, 2023 19:53:22 GMT
Hi , to activate the fader screen and related DSP settings, in addition to highlighting channels 1 and 4, it is necessary to set the topology flow parameter, in id3 it should basically be at 16, it should be set at 19, I have a Born, it was at 17 I tried all the values from 18 to 21, the rear speakers are activated but the center channel and the fader/dsp settings have disappeared
|
|
papad
New Member
Posts: 13
|
Post by papad on Nov 20, 2023 20:41:49 GMT
There seems to be a 1-click app now under retrofits for this, 50 credits I used the 1-click app, worked perfect for me. Also, since you need to connect JTP(junior timer power)-crimp pins in the socket, the pins are paired 1+,5- and 4+,8- for the two speakers. If you look closely into the connector of the infotainment unit, the numbers are seen for the two missing pair connectors. In the schematic here these numbers are missing/faulty.
|
|
|
Post by tghazi on Jan 20, 2024 23:27:50 GMT
Hi guys Please where can I fin signal flow topology in OBDeleven I searched for it in 5f module but I didn't find it
|
|